Home › Calculators › TV Mounting Height Calculator

TV Mounting Height Calculator

Find how high to mount your TV. Enter the screen size, your seated eye height and how far you sit, and get the ideal TV center height, where to put the wall bracket, the top and bottom edges, and how much to tilt it if it must go higher.

Last updated:

TV
in
in

Height with bezel from the spec sheet. Blank = screen height + 1 in.

in

Measure from the middle of the VESA holes to the screen center. Negative if the holes are below.

Room
in

Floor to your eyes when seated. Sofas: 38-44 in. Bed: 45-50 in.

ft

From your eyes to the screen.

Mounting position
in
in

Gap between the mantel and the bottom of the TV. Check your fireplace manual for heat clearances.

in
Enter your values to see the result.
Advertisement
Advertisement

How to use the TV Mounting Height Calculator

  1. Enter the screen size (diagonal) and, if you know it, the TV's full height with bezel from its spec sheet.
  2. Measure your seated eye height from the floor and the distance from your eyes to the wall.
  3. Choose the position: ideal eye level, above a fireplace or console, or a custom center height.
  4. Measure the mounting holes relative to the screen center so the bracket height comes out right.
  5. Mark the bracket height on the wall, and use the tilt suggestion if the TV sits above eye level.

TV height formulas

  • Screen height (16:9) = diagonal × 9 ÷ √(16² + 9²) = diagonal × 0.490. Width = diagonal × 0.872.
  • Ideal TV center = seated eye height. Bottom edge = center − TV height ÷ 2.
  • Above a fireplace: center = mantel height + clearance + TV height ÷ 2.
  • Bracket height = TV center + offset of the mounting holes above the screen center.
  • Viewing angle = atan((center − eye height) ÷ viewing distance). Tilt the TV down by about this angle.

Example: a 65 in TV is 31.9 in high (screen). With a 42 in eye height the center is 42 in, the bottom edge about 26 in and the top about 58 in. Above a 54 in mantel with a 4 in gap the center would be about 74.4 in, an upward angle of 15° from 10 ft.

16:9 TV sizes and heights at a 42 in eye level

TV sizeScreen widthScreen heightBottom edgeTop edge
43 in37.5 in21.1 in31.5 in52.5 in
50 in43.6 in24.5 in29.7 in54.3 in
55 in47.9 in27.0 in28.5 in55.5 in
65 in56.7 in31.9 in26.1 in57.9 in
75 in65.4 in36.8 in23.6 in60.4 in
85 in74.1 in41.7 in21.2 in62.8 in

Edges are for the screen only; bezels add a few tenths of an inch to about an inch. Always mount into studs or with anchors rated for the TV's weight, and keep the bracket level.

Frequently asked questions

How high should a TV be mounted?

The center of the screen should be at or near your seated eye height, which is about 40-44 in (102-112 cm) from the floor for most sofas. For a 65 in TV that puts the bottom edge around 24-28 in and the top edge around 56-60 in from the floor.

Where do I put the TV bracket on the wall?

The wall plate goes where the TV's mounting holes will be, not where the screen center is. Measure from the center of the VESA hole pattern to the center of the screen; add that to the TV center height if the holes are above center, or subtract it if they are below.

How high should a TV be above a fireplace?

Usually the TV bottom sits 4-12 in above the mantel, which often puts the center 70 in or more off the floor. That means looking up more than 15° from a typical sofa, so use a tilting or pull-down mount and check the fireplace manual for heat clearance.

How much should I tilt a TV mounted high?

Tilt it down by about the angle between your eye line and the screen center: atan(height above eyes ÷ viewing distance). A center 20 in above your eyes viewed from 10 ft is atan(20 ÷ 120) ≈ 9.5°, so tilt about 10°.

What viewing angle is comfortable?

Looking straight ahead or slightly down is most comfortable. Many home theater guides suggest keeping the vertical angle to the screen center under about 15°; beyond that, neck strain becomes noticeable over a full movie.

How far should I sit from a 65 inch TV?

For a 16:9 TV, about 1.2 to 1.6 times the diagonal gives a 40° to 30° field of view: roughly 6.5-8.7 ft for a 65 in TV. 4K TVs can be viewed closer than 1080p ones without seeing pixels.

How high should a bedroom TV be mounted?

Measure eye height while sitting or lying in bed, usually 45-50 in, and center the TV there or slightly above with a little downward tilt. Wall-mounting across from the bed at dresser height often works well.

Are all the tools on FreeToolCabin tested for quality and accuracy?

Yes! Every tool on our site undergoes automated Q/A testing in real browser environments to ensure high precision, correct output, and zero errors. If you happen to spot a bug or have a suggestion, please contact us at [email protected] and our team will review it right away.

Related tools

TV Viewing Distance CalculatorBest seating distance for your TV size and resolution (SMPTE, THX, 4K), or the best TV size.TV Size CalculatorFind a TV or monitor's width, height and area from its diagonal and compare two screens.Picture Hanging Height CalculatorExact nail height for a frame at 57 in eye level or above furniture, plus gallery spacing.Aspect Ratio CalculatorCalculate image sizes for 16:9, 4:3 and any ratio.Square Footage CalculatorTotal sq ft and m² for rooms of any shape, with cost estimate.Concrete CalculatorEstimate concrete volume, bags and cost.Paint CalculatorHow much paint for a room, minus doors and windows, in gallons or liters.Tile CalculatorHow many tiles and boxes you need for a floor or wall, with waste.Flooring CalculatorWork out flooring area, boxes needed and cost with waste allowance.Drywall CalculatorCount drywall sheets, screws, joint compound and tape for walls and ceilings.Brick CalculatorEstimate bricks, mortar volume and mortar bags for a wall, minus openings.Fence CalculatorWork out fence posts, rails, pickets and concrete bags for any fence length.Deck CalculatorDeck boards, joists, posts, screws and total cost from your deck size.Wallpaper CalculatorWork out how many rolls of wallpaper you need, with pattern repeat and waste.Stair CalculatorFind riser height, tread run, stringer length and angle, with IRC code checks.Board Foot CalculatorAdd up board feet and lumber cost for any list of boards, nominal or actual size.Insulation CalculatorFind the R-value to add for your climate zone and how many batts or blown-in bags to buy.Rain Gutter CalculatorSize gutters and downspouts from roof area, roof pitch and local rainfall intensity.Moving Cost CalculatorCompare DIY truck, full-service movers and container costs, with truck size and packing estimates.Concrete Block CalculatorCount concrete blocks (CMU) for a wall, minus doors and windows, plus mortar bags.Roof Pitch CalculatorConvert rise and run or an angle to roof pitch x/12, degrees, slope % and rafter multiplier.Price per Square Foot CalculatorFind price per sq ft or m², total price or area, and compare several homes by value.House Flipping CalculatorFix-and-flip profit, ROI and 70% rule max offer from purchase, rehab, holding and sale costs.Stud CalculatorCount wall studs and plates from wall length, spacing, corners and openings.Carpet CalculatorCarpet for your rooms in sq ft and sq yd from a 12 or 15 ft roll, with padding and cost.Baseboard CalculatorLinear feet of baseboard and number of pieces for your rooms, minus doorways.Grout CalculatorGrout in kg, lb and bags from tile size, joint width, depth and area.Asphalt CalculatorTons of asphalt from area and thickness at 145 lb/ft³, with volume and cost.Sand CalculatorSand in cubic yards, m³, tons and bags for any area and depth.Siding CalculatorSiding squares, panels and J-channel from walls and gables minus doors and windows.Concrete Steps CalculatorConcrete volume and bags for poured steps from step count, rise, run, width and landing.Baluster Spacing CalculatorNumber of balusters and exact gap and on-center spacing for a railing under the 4-inch rule.Caulk CalculatorCaulk volume and number of 10.1 oz cartridges or squeeze tubes from joint length and size.Ceiling Fan Size CalculatorCeiling fan blade span, downrod length and minimum airflow (CFM) for any room.Concrete Mix Ratio CalculatorCement bags, sand, gravel and water for any concrete mix ratio (1:2:3, 1:2:4, M15, M20).Curtain Size CalculatorCurtain length, panel width and number of panels from your window size and fullness.Deck Stain CalculatorGallons of deck stain or sealer for the floor, railing and stairs, by coats and wood condition.Dehumidifier Size CalculatorPints-per-day dehumidifier capacity for your room size and dampness, old and new ratings.Solar Panel Output CalculatorDaily, monthly and yearly kWh from your solar panels, and what that power is worth.Space Heater Cost CalculatorCost to run a space heater per hour, day, month and season, high vs low vs eco.Storage Unit Size CalculatorList your furniture and boxes to find the right storage unit, 5x5 to 10x30, with fill %.Event Table CalculatorHow many tables and chairs for a wedding or party, with head table, linens and floor space.Attic Ventilation CalculatorFind the attic net free vent area (1/150 or 1/300) and how many ridge, soffit and box vents.Concrete Weight CalculatorWeight of a concrete slab, block or cylinder in lb, kg and tons, with hauling loads.Deck Railing CalculatorPosts, rails, balusters, post caps and hardware for your deck railing runs.Drywall Mud CalculatorJoint compound buckets, tape rolls and drywall screws from square feet or sheets and finish level.Even Spacing CalculatorSpace shelves, posts, pickets or pictures evenly: equal gap, on-center spacing and every mark.HVAC Replacement Cost CalculatorEstimate the installed cost and tonnage of a new AC, furnace, heat pump or mini-split.Linear Cut OptimizerFit cut lengths onto boards, pipe or bar stock with saw kerf: cutting plan, waste and board count.Clay Shrinkage CalculatorFired size from wet size, throw size for a target, or shrinkage % from a test tile.SEER Savings CalculatorAnnual savings and payback from upgrading to a higher SEER or SEER2 air conditioner.Self-Leveling Concrete CalculatorBags of self-leveling underlayment, mixing water and primer from floor area and depth.Septic Tank Size CalculatorRecommended septic tank gallons and drain field size from bedrooms and occupants.Spiral Staircase CalculatorPlan a spiral stair: treads, riser height, tread angle, walkline depth and headroom checks.Spray Foam CalculatorBoard feet of open or closed-cell spray foam, kits needed, R-value and cost from area and depth.Stair Carpet CalculatorCarpet for stairs in square and linear yards, or stair runner length, from steps and landings.Stucco CalculatorStucco volume, bags of mix, lath sheets and sand from wall area, coats and thickness.Thinset CalculatorBags of thinset mortar from tile area and trowel notch size, with back-buttering allowance.Wainscoting CalculatorBox layout, panels, rails, stiles, beadboard sheets and cap trim linear feet for any room.Water Softener Size CalculatorDaily grains and the right water softener capacity from hardness, iron and household size.Epoxy Resin CalculatorEpoxy volume for river tables, countertops, floors and coasters, with resin:hardener split.Fence Post Concrete CalculatorConcrete volume and number of 40, 50, 60 or 80 lb bags for fence post holes.Heating Cost CalculatorYearly heating cost for gas, propane, oil, electric, heat pump and wood pellets compared.Home Appreciation CalculatorProject home value by year from a growth rate or find the rate from today's value, with equity.Home Maintenance Cost CalculatorYearly and monthly home upkeep budget using the 1% rule, cost per sq ft or home age.Joist Span CalculatorMaximum floor or deck joist span for any lumber size, spacing, species, grade and load.Linear Feet CalculatorAdd up lengths or convert square feet to linear feet by board width, with boards and cost.Lumens CalculatorLumens a room needs from foot-candle targets, plus bulb count and watts-to-lumens equivalents.
See all 99 Home & Construction Calculators →